How much does a metal roof cost?
$1,125 per square (100 sq ft of roof) installed, with a $10,000 minimum job. A roof with 20 squares works out to $22,500 before any change in scope. Every home gets its own written quote.
Can I finance a metal roof?
Yes, subject to credit approval. Financing runs as low as 6.99% APR for qualified borrowers over 10 years, $0 down. That's about $116.06 a month for every $10,000 financed (120 months).
Which metal roof brands do you install?
Englert Series 1300 and Metal Alliance 150MS/200MS panels, over Polyglass Polystick MTS Plus underlayment. We pick the line by county, deck and HOA rules.
Standing seam or exposed-fastener panels?
Standing seam hides the fasteners under a raised seam held by clips. Exposed-fastener panels are screwed through the face. Outside the HVHZ, the code minimum slope is ¼:12 for standing seam and 3:12 for lapped seams without sealant (FBC 1507.4.2).
What gauge is the metal?
Englert Series 1300 is 24 ga (0.024 in.) steel or 0.032 in. aluminum in its Miami-Dade NOAs. Metal Alliance 150MS/200MS comes in 22, 24 or 26 ga steel, .032 or .040 aluminum, or copper.
Is metal OK near the ocean?
Choose the metal and coating for salt air. Metal Alliance offers Fluropon Coastal on aluminum with a 25-year limited warranty, and Englert offers coastal-coverage finish warranties. Terms depend on the line, so we confirm them in writing for your address.
What are the HVHZ rules for metal roofs?
In Miami-Dade and Broward, every component needs a current product approval (FBC 1512.2.1), metal panels are tested to TAS 125, and the install follows the approval and RAS 133 (FBC 1518.9).
What about Palm Beach County?
Palm Beach is outside the HVHZ. Metal panels follow FBC 1504.3.2 testing and FBC 1507.4 slope and material rules, with a Florida Product Approval or Miami-Dade NOA.
Can a metal roof lower my insurance?
It can help. On form OIR-B1-1802 (Rev. 04/26), Question 4 covers the roof covering and its product approval, and Question 8 covers secondary water resistance. Your insurer sets the actual credit.
Do you tear off the old roof?
Yes. Every metal job includes tear-off of the old roof down to the deck before the new underlayment and panels go on.
How long does a metal roof take?
Often three to five days on the roof, after the permit, which usually takes one to four weeks.
What warranty comes with it?
A 10-year labor warranty from Republic. Product and finish warranties come from the manufacturer and depend on the line and location.
Where do you install metal roofs?
Miami-Dade, Broward and Palm Beach counties only.
Do you repair metal roofs?
No. We install and replace roofs. We don't offer roof repairs.